Concrete Tank
  1. Home
  2. Articles
  3. Underground or Above-Ground Water Tank How to Decide

Article

Underground or Above-Ground Water Tank How to Decide

Our concrete tanks work both ways, buried or on a base. So the real question is not which tank is stronger but which method suits your ground, your space and how you use water. This comparison walks you through it.

Updated · Concrete Tank team

Reinforced concrete water tanks standing above ground on bases

Ask anyone about a concrete water tank and the first question comes back fast underground or above ground? Most people answer out of habit, going with whatever the neighbours have or the contractor suggested. It deserves a bit more thought, because changing your mind after the pit is dug or the base is poured means starting again.

One fact simplifies things. Our seven tank sizes are the same either way the same reinforced concrete cast in our Riyadh factory, the same two waterproofing layers, the same 10-year warranty on manufacturing and installation covering cracks and leaks. You are not choosing between two products. You are choosing how a single product fits your site.

The comparison at a glance

PointUndergroundAbove ground
Site preparationPit, level floor, backfillEngineered concrete base
Surface spaceMostly returned, opening stays visibleFully occupied
AppearanceAlmost hiddenVisible, around 3 m tall
Summer sunShielded by groundExposed, depending on shade
GroundwaterNeeds special thoughtRarely a concern
Rock near the surfaceMakes digging hardNo obstacle
Checking outer wallsHard once backfilledEasy by eye
Filling from mainsOften easier, sits below the lineDepends on mains pressure and inlet height

The rest of this article explains when each row actually changes the answer.

Space and looks

For villas and apartment buildings this often settles it. A 24 m³ tank has a footprint of about 12.8 m². Put it underground and you get most of that back. Stand it on a base and you lose that area plus some room around it.

Then there is height. Our tanks stand 2.80 to 3.30 m, and a base adds to that. That can clear the boundary wall, show from the street, shade a neighbour, or darken a window on a side passage. Read where to put a tank in a villa alongside this if that describes your situation.

The opposite applies on big plots. If space is plentiful and looks do not matter, as on many farms and yards, above ground is an easy call no excavation, no backfill, no concern about what lies below.

The work before the tank arrives

Underground means an excavator, a pit larger than the tank, somewhere for the spoil, a level floor, and backfilling afterwards. With tanks up to 3.30 m tall you are talking about a deep hole, so side support and worker safety are part of the job. Buried services complicate matters further.

Above ground means a concrete base designed by an engineer, because water alone is heavy. The 29 m³ wide puts about 29 tonnes of water on 12.8 m², roughly 2.3 tonnes per square metre before you add the concrete. A load like that calls for a calculated base and known soil.

Both routes are set out step by step in how to prepare the site. With either one, the installation itself usually takes one day once the site is ready.

Soil and groundwater

This is where the answer can flip, even if you had your heart set on burying the tank. When groundwater sits close to the surface, a buried tank faces two separate forces

  1. Water and damp pressing on the walls from outside, which is the job of the outer bitumen layer.
  2. Buoyancy. An empty tank in saturated ground is pushed upward, like any hollow object in water. This is an engineering question that has to be answered before digging, and it is the point people most often overlook.

It matters most near the coast and on salt flats, as can be the case in parts of Jeddah, Dammam, Jubail, Jazan and Al Ahsa. That does not describe every plot in those places, as conditions change from site to site. Ask neighbours and your contractor how deep water sits in your area, then read about tanks and high groundwater.

Rock presents the reverse problem, in parts of Abha, Taif and Madinah for example. There, digging itself is the issue, and if it needs special equipment, a base can save a lot of trouble. In sand, holding the pit sides up becomes the main concern.

Heat and summer sun

Everyone in the Kingdom asks about this. Ground shields a buried tank from direct sun, while a tank on a base takes it. But concrete walls pass heat much more slowly than thin plastic or fiberglass, which is part of the comparison in concrete vs plastic tanks.

If you go above ground and heat concerns you, choose the location carefully. Use the side shaded by the house or wall for part of the day, and avoid full midday exposure if you can. We will not quote you a temperature difference, because it depends on the site, the shade and how quickly the water is used. Either way, both methods are workable in most cities.

Filling and pumping

Here is a practical difference few people consider. Filling from the mains is usually easier with a buried tank, since its inlet tends to sit below the supply line. An above-ground inlet is high, and mains pressure in some neighbourhoods may struggle to reach it, so you might need a different arrangement. A water truck has its own pump and handles either setup as long as it can reach the fill point, as explained in our truck filling guide.

Drawing water differs as well. A buried tank needs a pump to lift water up to the house. An above-ground tank feeds a pump more easily, but do not expect it to replace one, because its height will not give enough pressure for a whole home. Either way you need a suitable pump; what changes is the type and where it sits. The pipework is covered under tank plumbing connections.

Inspection and upkeep

With an above-ground tank you can walk around it. Any damp patch is obvious and easy to locate. A buried tank's walls are out of sight after backfilling, so you rely on watching the water level and checking joints, as described in the leak detection guide.

Cleaning access is through the opening in both cases. On a buried tank, keep that opening above ground level so rain and wash water cannot run in. On a tank above ground, plan a safe way to climb up to it. Our tank cleaning guide takes you through the rest.

The crane matters in both

Both methods need a crane, but the concerns differ. Beside a pit, the crane has an open edge to stay away from, especially in loose soil. With a base, the tank has to be set down accurately on a raised surface. In either case, the street, cables and shades get checked the same way, and truck and crane access has the full list.

When underground is the right call

  • Space is tight and you want the surface back for a garden, or for parking once the load has been reviewed.
  • Looks matter and the tank should not show from the street or block a view.
  • Groundwater is deep and the ground can be dug without hard rock.
  • Mains pressure is low and you want filling to be simple.
  • It is a new building and excavation can be coordinated with the foundations.

When above ground is the right call

  • Groundwater is shallow, or the plot is on salt flat.
  • The ground is rocky and hard to excavate.
  • You have generous space, such as on a farm or a large yard.
  • There are many buried services that cannot easily be moved.
  • You want to be able to see the tank walls yourself.
  • It is a finished villa, and digging deep beside its foundations would be a major undertaking.

Three situations worked through

A family villa with a small yard. Ten people at 250 litres each use 2,500 litres a day. A 22 m³ square tank gives about 8.8 days, on a 10.9 m² footprint. In a small yard that is a lot of surface, so underground makes sense if the ground allows. See the villa water tank page.

A spacious farm on sandy ground. Room is not the problem, and holding a deep pit open in sand is a real effort. A tank on a base near the well is usually simplest. More in our farm water storage guide.

A new apartment building. Set-backs and parking dominate. Planned from the start, a buried tank frees up space. For 30 residents at 250 litres, daily use is 7,500 litres, so a 29 m³ tank gives about 3.9 days. Several connected tanks extend that. Our building water storage guide covers this.

A simple way to decide

Go through these in order, and let the first firm answer lead you.

  1. Is groundwater shallow, or is the plot on salt flat? If yes, lean above ground and investigate before any digging.
  2. Is the ground rocky or full of buried services? If yes, above ground moves ahead.
  3. Is surface space valuable to you? If yes, underground moves ahead.
  4. Would a visible tank bother you or your neighbour? If yes, underground moves ahead.
  5. Would the dig be close to foundations? If yes, get an engineer to look before you decide.

Still unsure? Do not start digging. Send your location and site photos on WhatsApp and we will reply with a written quote and a date. Use the calculator to get your capacity first. We serve all regions of the Kingdom, with free delivery and installation inside Riyadh and a fee based on size and distance elsewhere.

FAQ

Is it the same tank for both installations?
Yes. The same precast tank goes underground or above ground on a base, with the same two waterproofing layers a water-safe chemical lining inside and bitumen outside. The difference lies in preparing the site.
Which is cheaper overall?
There is no single answer. Underground involves excavation and backfill, while above ground involves an engineered base, and both depend on your soil. Get your contractor to price both preparations, and ask us for a written quote for the tank.
Can I bury the tank only part of the way?
This happens on some sites, especially with rock or sloping ground. It combines the conditions of both methods, so the buried and exposed parts both need thinking through. Send site photos and ask before you fix a depth.
Does water stay cooler underground?
In general the ground shields a buried tank from direct summer sun. Above ground, the tank is more exposed, though thick concrete passes heat far more slowly than thin plastic or fiberglass. The real difference depends on your site and shade.
Could I switch methods after installation?
Treat that as off the table. Changing means another crane visit, a new base, and filling the old pit. It is far better to spend the time on the decision before digging.
What about an apartment building?
Set-backs and parking usually govern this. Underground frees space above but needs thought near foundations, and above ground needs clear space. See the building water tank page and send us photos of the plot.

Ready to order your tank?

Message us on WhatsApp for a final delivered price to your city and an installation date.